RC10B6 FT Aluminum Bulkhead, 10g
The chassis plate on most 1:10 Team Associated race vehicles (RC10B6.3, RC10T6.2, RC10SC6.2) is manufactured with a 27.5 degrees kickup angle at the nose.
These bulkheads allow for adjustment between 25 degrees and 30 degrees of kickup depending on the direction it is installed.
Install the "-2.5Deg" or "25Deg" side of the bulkhead towards the front of the car for 25 degrees of kickup.
Install the "+2.5Deg" or "30Deg" side of the bulkhead towards the front of the car for 30 degrees of kickup.
These bulkheads allow for adjustment between 25 degrees and 30 degrees of kickup depending on the direction it is installed.
Install the "-2.5Deg" or "25Deg" side of the bulkhead towards the front of the car for 25 degrees of kickup.
Install the "+2.5Deg" or "30Deg" side of the bulkhead towards the front of the car for 30 degrees of kickup.
This part fits the following vehicles
- RC10B6
- RC10B6D
- RC10B6 Club Racer
- RC10B6.1
- RC10B6.1D
- RC10T6.1
- RC10SC6.1
- RC10B6.1DL
- RC10B6.2
- RC10B6.2D
- RC10T6.2
- RC10SC6.2
- RC10B6.3
- RC10B6.3D
- RC10B6.4
- RC10B6.4D
- RC10T6.4
- RC10SC6.4
-
Set Screws, M3x2.5 mm
#31500
$6.99Set Screws, M3x2.5 mmSorry, item information is not available. But check the Documents or Parts tabs…